MIL-PRF-46374G
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as
qualification inspection (see 4.3) and conformance inspection (see 4.4).
4.2 Inspection conditions. Unless otherwise specified, all inspections shall be performed at
15.6 °C (60 °F) to 32.2 °C (90 °F), at barometric pressure of 710 mm (28 inches) to 790 mm
(31 inches) of mercury and maximum relative humidity of 80 percent.
4.3 Qualification inspection. Qualification inspection shall be performed on five complete
assemblies when a qualification sample is required (see 3.1). This inspection shall include the
examination of 4.5, in accordance with tables V through IX, and the tests of 4.6. (The table IX
tests, however, are exclusive to Qualification testing.)
4.3.1 Qualification sample. A quantity of 20 watches shall be submitted for qualification testing
(see 6.3). Testing shall be performed at a laboratory facility acceptable to the government.
Sample watches submitted for testing shall be derived from normal production and be indicative
of normal production equipment and procedures. Ten of the watches shall be packed in
accordance with the level of packing specified in the purchase order or contract. The 20 watch
samples shall be identified by an attached tag containing the following information:
a. Sample for qualification tests
b. Submitted by (name) (date) for qualification tests in accordance with requirements of
MIL-PRF-46374G under authorization of (reference letter authorizing test)
c. Manufacturer's model or part number
d. Name of manufacturer
4.4 Conformance inspection. Conformance inspection shall be performed in accordance with
inspection provisions set forth herein. The characteristics shown in tables V, VI, VII and VIII
shall constitute minimum inspections to be performed by the supplier prior to government
acceptance or rejection by item or lot.
4.5 Examination.
4.5.1 Conformance inspection, mechanical. Inspection shall be in accordance with table V.
TABLE V. Conformance inspection, mechanical.
Characteristic
Requirement
Test
Crystal strength
3.4.6
4.6.1.1
Strap
3.4.7
4.6.2
Battery servicing
3.4.9.1
4.6.3.1
Finish and color
3.4.9.2
4.6.3.2
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business