INCH-POUND
MIL-DTL-81219C
20 April 2009
SUPERSEDING
MIL-I-81219B(AS)
7 October 1987
DETAIL SPECIFICATION
INDICATOR, ELAPSED TIME, ELECTROCHEMICAL
Inactive for new design after 24 August 1998.
This specification is approved for use by all Departments and Agencies of the Department of
Defense.
1 SCOPE
1.1 Scope. This specification covers the design and performance requirements for
lightweight, small and low resolution electrochemical elapsed time indicators.
1.2 Part or Identifying Number. The PIN is as specified on the applicable MS sheet.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all specified
requirements of the documents cited in sections 3 and 4 of this specification, whether or not they
are listed.
Comments, suggestions, or questions on this document should be addressed to Defense Supply Center Richmond,
ATTN: DSCR-VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-5616 or e-mailed to
STDZNMGT@DLA.MIL. Since contact information can change, you may want to verify the currency of this
address information using the ASSIST database at https://assist.daps.dla.mil.
AMSC N/A
FSC 6645
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business